50-53 cad clutch cross shaft needed or mearurements.

[johnwalker]

i have a 1950 61 series with manual trans. somewhere along the line i misplaced the cross shaft that goes between the frame and bellhousing. there's a bar from the clutch pedal to one arm on the cross shaft and another adjustable rod between the outer arm on the cross shaft to the clutch release fork. i need both bars also. fits 50-53 only, including hearse/ambulance. any leads appreciated. if you happen to have one available to take some precice measurements, i could make one.  thanks,  jw  206 789 6800 or jwworkshop@aol.com  seattle, wa.

[johnwalker]

stagnating down there at the bottom of the forum. someone must have at least a measurement so i can make one. please?

[johnwalker]

length of tube, length of both arms on the tube and the angle of the arms to one and other and i'll make one. anyone have time to measure one? take a picture of one? i can fake it, but actual measurements would be better. standard trans 50-53 cars and hearse/ambos only.